The life span of this crushing maker bounds up with operation as well as maintenance, if you do it properly and also timely, it will certainly be an expert concerning twenty years. Its installation actions are the crucial procedure before the tools running and also being run. The initial thing we need to understand and also maintain in our mind is its functioning principle.

The movable cone and repaired cone actions through the continual implementation of the different materials left near the busted function in the making use of procedure prior to, to be sensibly accurate for tools installment, installment of tools, the devices rack is to maintain the different components inside the tool key to stability, and also therefore the setup of devices in stringent conformity with the requirements, not the installation as well as appointing discrepancies create the device to normal operation and also serious damages to tools failure, impacting the smooth and its manufacturing capability.

When installing the rack of cone crusher, the shelf should be kept the straight and upright nature, if needed, use the horizontal scale on the ring base. Use vertical netsuke to check the straight and upright centerline. The base can be readjusted the level by making use of wedge change, after change to re-tighten the support screws as well as the strong grouting.

After second grouting and also the cement layer to be set, secure the wedge block under the base of the nordberg cone crusher wear crusher, and load the gap of the adjustment wedge with cement, re-check and determine the upright and horizontal performance, avoiding to produce solitary direct exposure of the copper sleeve on the base of cone crusher, the eccentric produce deterioration, as well as affect the stability of the gadget seal. When cone crusher installment of shelf, to make certain the accuracy and stability of the devices installation, this can make the last manufacturing to make the most of effectiveness.

If you utilize it for the very first time, the following points should be kept in mind.

1. It has been debugged before leaving factory, but after you set it up, simply exercise it as well as inspect whether the devices failure exits or not.

2. It is forbidden to begin it with load; all the stones in squashing chamber must be cleaned. Inspect the discharging port dimension; is it the right dimension you wish to have? If not, just adjust it.

3. Cable as well as any kind of added wires must be under the typical conditions.

4. It will not start when the oil temperature level is under 20.